Irrigation Technician / Installer Job Description
Commercial Irrigation
Installs, troubleshoots and services commercial irrigation: mainlines and laterals, valves and manifolds, heads and nozzles, controllers and sensors, and the low voltage wiring that ties them together. Installation work means trenching, pulling pipe, solvent and gasketed joints and head layout to designed coverage. Service work is mostly diagnosis, because most calls turn out to be a wire fault, a failed valve, or a controller programmed by somebody who no longer works there.
What this seat pays
Federal figures: BLS Occupational Employment and Wage Statistics, May 2025, national, SOC 37-3011. The range is the 10th to 90th percentile and the median is $39,150. It is not adjusted for experience or region, and it is not a My Trade Talent band.
Pay, location and the date prepared are blank in the Word version on purpose. They depend on your market and your margins, and a template that guesses at them is worse than one that leaves them to you. The figure above is here so the guess is at least anchored.
The seat
| Reports to | Irrigation Service Manager or Crew Foreman |
| Direct reports | None (may direct a helper or laborer) |
| FLSA status | Non-exempt — confirm with counsel |
| Trade | Commercial Irrigation |
| Pay band | $31,150 to $56,730 — BLS 10th to 90th percentile |
Where the role goes next. Technicians move to lead, service manager, or into design and water management auditing.
Essential duties (15)
- Installs mainlines and laterals by trencher, vibratory plow or hand digging to the depth and bedding the plan and local code require.
- Makes up PVC and poly connections, solvent weld, gasketed, insert and compression, with correct primer, cure time and thrust support.
- Builds valve manifolds and sets valve boxes to grade with enough slack and union to service the valve without digging again.
- Installs rotors, sprays, nozzles, drip zones, emitters, filters and pressure regulators, and sets spacing and arc to the designed coverage and precipitation rate.
- Pulls and splices low voltage control wire with waterproof connectors, labels zones, and installs spare conductors for future use.
- Mounts and programs controllers, including two-wire and smart controllers, and installs rain, freeze, flow and soil moisture sensors and master valves.
- Troubleshoots electrical faults with a multimeter and wire tracker, including solenoid resistance, open and shorted commons, shovel damaged wire and failed field splices.
- Diagnoses hydraulic problems such as pressure loss, low flow, water hammer, weeping valves, broken laterals and plugged nozzles and drip, and corrects the cause rather than the symptom.
- Performs seasonal startups and winterization with zone by zone activation, head adjustment, pressure checks, blowout at safe pressure and a documented shutdown.
- Locates and repairs leaks and line breaks under turf, beds and pavement, and restores the surface so the repair is not the first thing the customer sees.
- Calls in the utility locate before digging, honors the marks, hand digs the tolerance zone and records the ticket number on the work order.
- Keeps the service record for every call with site, zone, findings, parts used and what was tested after the repair, plus photographs of conditions the customer should see.
- Audits coverage and run times, adjusts schedules for season and plant type, and reports water waste and conditions the customer should budget for.
- Maintains truck inventory, trencher and compressor, meters and locators, and the condition of shovels, pipe tools and valve keys.
- Backfills and compacts trenches, restores turf and hardscape, and leaves the site clean with spoil, pipe cuttings and failed parts removed.
Qualifications
- Two years installing or servicing commercial irrigation, or three years in landscape or underground utility work including irrigation time.
- Able to troubleshoot low voltage control circuits with a multimeter and explain what the readings mean.
- Working knowledge of PVC and poly pipe methods, valve types, head families and basic hydraulics including pressure loss, flow and precipitation rate.
- Valid driver license with an acceptable MVR; the role drives a service truck and may tow a trencher.
- Able to dig by hand, lift 50 to 75 pounds, kneel and work in wet trenches, and work outdoors in heat for a full shift.
- Able to read an irrigation plan and as-built and to mark up the as-built when the field changes.
- Able to call a utility locate and work correctly inside the tolerance zone.
- Irrigation Association certification such as Certified Irrigation Technician, Certified Irrigation Contractor or Certified Landscape Irrigation Auditor.
- State irrigation or landscape contractor license or registration where required.
- Experience with two-wire systems and central control platforms.
- Pump station, booster pump and reclaimed water system experience.
- Backflow prevention assembly tester certification already in hand.
- Trencher, vibratory plow, skid steer and vacuum excavation experience.
- Spanish and English language ability for crew and property staff communication.
The line between these two columns is the one that costs you candidates. Everything in the preferred column that gets written into a posting as a requirement removes people who could do the job, and in a trade with a shortage that is a self-inflicted wound.
Credentials, and who verifies them
| Credential | Status | Verify with |
|---|---|---|
| Irrigation Association certification | Preferred | Irrigation Association certificant lookup and certificate on file |
| State irrigation or landscape contractor license or registration | Where the state requires it | State licensing board lookup at hire and at renewal |
| Backflow prevention assembly tester certification | Where the state requires it | State program or water purveyor tester registry |
| Driver license and MVR | Required | State DMV record pulled at hire and annually |
| Utility locate and trenching competent person training | Required | Internal training records and a documented field evaluation |
| OSHA 10 construction card | Preferred | Training provider card and DOL outreach verification |
Verify before an offer rather than after. A credential taken on trust at offer is the most expensive line on this page. We track commercial irrigation licensing in 39 states; which of them applies depends on where the work is, not where the company is.
Physical demands
| Activity | Frequency |
|---|---|
| Standing and walking over turf, planting beds, slopes and uneven ground | Constant (over 2/3 of shift) |
| Working outdoors in heat, humidity, sun and rain | Constant (over 2/3 of shift) |
| Hand digging, shoveling and trenching with spade and pick | Frequent (1/3 to 2/3 of shift) |
| Kneeling, squatting and working on hands and knees in wet trenches and valve boxes | Frequent (1/3 to 2/3 of shift) |
| Working in wet and muddy conditions with hands and clothing soaked | Frequent (1/3 to 2/3 of shift) |
| Lifting and carrying 50 to 75 pounds of pipe, valves, fittings and hose | Frequent (1/3 to 2/3 of shift) |
| Bending and reaching at or below ground level for extended periods | Frequent (1/3 to 2/3 of shift) |
| Driving a service truck between properties | Frequent (1/3 to 2/3 of shift) |
| Operating a trencher, vibratory plow or compactor with hand, arm and whole body vibration | Occasional (under 1/3 of shift) |
| Fine motor work splicing wire and setting nozzles and small parts | Occasional (under 1/3 of shift) |
| Exposure to treated turf, reclaimed water and biological material in standing water | Occasional (under 1/3 of shift) |
| Working near traffic on medians, parking lots and roadside landscape | Occasional (under 1/3 of shift) |
This is the section a reasonable accommodation decision actually turns on, which is why it is role specific rather than copied across a trade. An estimator sits and walks sites; a screed operator stands beside hot asphalt all day.
Work environment
The work is outdoors on commercial properties, meaning office parks, retail centers, homeowner associations, campuses, medians and athletic fields, in whatever the season brings. Technicians work in open trenches, valve boxes, vaults and mechanical rooms. Hazards include buried utilities, trench collapse at depth, traffic on medians and lots, pressurized water, shock on controller and pump circuits, treated turf and reclaimed water, insects and snakes, and heat illness in summer.
Tools and equipment
The company provides the truck, trencher, compressor, pipe tools, wire locators and trackers, multimeters, pressure gauges, parts inventory and PPE. The technician owns hand tools including channel locks, strippers, knives, screwdrivers, a valve key and a personal multimeter, plus work boots and rain gear, and is accountable for assigned meters and locators.
How performance is measured
| Measure | What it captures |
|---|---|
| First visit fix rate | Share of service calls resolved on the first trip without a return for parts or a second diagnosis |
| Calls completed per day | Service throughput against the route plan for the property mix |
| Callback rate | Repeat visits for the same fault inside the warranty window |
| Installation production against estimate | Feet of pipe, heads and zones installed per crew day versus the bid |
| Utility strikes and damages | Line strikes, cut control wire and hardscape or turf damage per job |
| Coverage and water use results | Measured improvement in coverage and run time schedules on audited sites |
| Service documentation completeness | Tickets with findings, parts and post repair test results complete enough to bill and to defend a warranty claim |
These are the same measures the annual review for this role is built on, so the document you hire against and the document you rate against are measuring one thing.
Reading a resume for this seat
What separates a strong Irrigation Technician / Installer from a plausible one, on paper and in the first ten minutes of a call:
- Uses a wire tracker and a solenoid test rather than digging to find the fault
- Knows head spacing and precipitation rate, not just which head fits
- Has programmed smart controllers and understands what the sensors are actually doing
Screen for it: 3 questions and what a strong answer contains
A job description tells you what you need. These tell you whether the person in front of you has it. Each one comes with what a strong answer contains, because an interviewer who does not know that is persuaded by fluency, which is exactly what the question was supposed to see past.
A zone will not come on and the controller shows no fault. How do you trace it?
What a strong answer containsSplits it at the controller: puts the zone into manual and checks whether the controller is sending voltage to that station. If it is, the fault is in the field - the wire, a splice, or the solenoid - so they check resistance at the controller to see whether the circuit is open or shorted and work from there. If it is not, it is the controller output or the programme. Checks the master valve and the water supply first, because a zone that will not come on sometimes has no water.
Follow up with: What resistance reading would make you suspect the solenoid rather than the wire?
How do you check that a zone is applying water evenly?
What a strong answer containsRuns a catch-can test rather than watching it: containers spread across the zone, run for a measured time, and compares what each caught to get the distribution uniformity. Looks at what the result points to - heads mismatched in type or nozzle, spacing that is not head to head, pressure too low or too high, tilted or sunken heads, or something blocking the throw. Fixes the cause rather than adding run time to the dry spots.
Follow up with: The dry spots are between heads. What does that tell you?
Walk me through winterising a commercial system.
What a strong answer containsShuts off and isolates the supply, drains what will drain, then blows out zone by zone at a pressure below the system's limit and a volume that will actually clear the laterals, keeping each zone running only as long as water is coming out so heads are not run dry. Opens the backflow test cocks and drains the assembly, protects it, and shuts down and drains the controller or sets it to off. Documents what was done.
Follow up with: Why is blowing out at too high a pressure worse than not blowing out at all?
The mistake this seat invites
Hiring landscape labourers into irrigation service. The troubleshooting is electrical and hydraulic diagnosis, and installation experience does not supply it.
How long this takes to fill
We publish no commercial irrigation median of our own yet, so this is the all-trades figure: My Trade Talent's median commercial trades hire took 21 days across 88 searches closed in 2026 year to date, counted as calendar days from our first contact with the candidate to the hire.
Worth writing on the requisition before you post it. The cost of the vacancy runs from the day the seat empties, not from the day you start looking, and the calculator will put a number on it for your billing rate.
Questions employers ask about this role
What does an Irrigation Technician / Installer do?
Installs, troubleshoots and services commercial irrigation: mainlines and laterals, valves and manifolds, heads and nozzles, controllers and sensors, and the low voltage wiring that ties them together. Installation work means trenching, pulling pipe, solvent and gasketed joints and head layout to designed coverage. Service work is mostly diagnosis, because most calls turn out to be a wire fault, a failed valve, or a controller programmed by somebody who no longer works there. The full description below lists 15 essential duties in trade terms, with physical demands and frequencies.
What qualifications does an Irrigation Technician / Installer need?
7 requirements are written as non-negotiable for this seat. The first 3: Two years installing or servicing commercial irrigation, or three years in landscape or underground utility work including irrigation time; Able to troubleshoot low voltage control circuits with a multimeter and explain what the readings mean; Working knowledge of PVC and poly pipe methods, valve types, head families and basic hydraulics including pressure loss, flow and precipitation rate. A further 7 qualifications are preferred rather than required, which is the distinction that decides whether a good candidate gets screened out by your own posting.
What credentials should I verify before making an offer to an Irrigation Technician / Installer?
4 credentials on this role are either required outright or required where the state requires it: State irrigation or landscape contractor license or registration, Backflow prevention assembly tester certification, Driver license and MVR and Utility locate and trenching competent person training. Each one has a named place to verify it in the table below. Verify before the offer rather than after; a credential taken on trust at offer is the most expensive line in a job description.
Is an Irrigation Technician / Installer exempt or non-exempt?
Non-exempt — confirm with counsel. FLSA status turns on the duties actually performed rather than the job title, and the duties for this seat are listed below so a classification decision has something to rest on. We are not lawyers and the note here is a starting point for counsel, not a determination.
What should an Irrigation Technician / Installer be paid?
$31,150 to $56,730. Federal figures: BLS Occupational Employment and Wage Statistics, May 2025, national, SOC 37-3011. The range is the 10th to 90th percentile and the median is $39,150. It is not adjusted for experience or region, and it is not a My Trade Talent band.
How long does it take to hire an Irrigation Technician / Installer?
We publish no commercial irrigation median of our own yet, so this is the all-trades figure: My Trade Talent's median commercial trades hire took 21 days across 88 searches closed in 2026 year to date, counted as calendar days from our first contact with the candidate to the hire.
What is the most common hiring mistake in this seat?
Hiring landscape labourers into irrigation service. The troubleshooting is electrical and hydraulic diagnosis, and installation experience does not supply it.
One time
Where should we send it?
Tell us who you are once and every document on this site downloads for you from then on, with no form in the way. We are a recruiting firm: someone may call about the roles you are hiring for.